OmniTurn
TO UPDATE SOFTWARE ON OMNITURN CNC HARD DRIVE:
1. Go back to Download
Software .
2. Create SYSTEM DISK for your system per instructions
on that page.
3. Power up your OmniTurn, then drop to DOS by holding
left "Shift" key and pressing "Esc" key.
4. Put new system disk in lower drive. At C:\OMNITURN
prompt, type A:\UPD then press Rtrn.
5. Several files will copy from floppy to hard drive,
then "system files copied" message will appear.
6. Set power OFF, wait a few seconds, then set power ON
to reboot.
This method insures that you have latest
System Disk on hand as well.
Questions?
Call OmniTurn: 541 332 7004
or email service@omniturn.com
01/29/2003