5hp OmniTurn GT-Jr. including: flood coolant, pneumatic collet closer, solid-state hard drive, 220V 1 or 3 phase, 9" Z axis travel, extended X axis travel (12")
(Part Number 510-00-000)

Call for factory-direct price

C-Axis OmniTurn GT-Jr. including: flood coolant, pneumatic collet closer, solid-state hard drive, 220V 1 or 3 phase, 9" Z axis travel, extended X axis travel (12")
(Part Number 570-00-000)

Call for factory-direct price

4 degree spindle nose option (Part Number 693-39-001)

NoCharge

½" center height option (Part Number 692-19-001)

NoCharge

2" center height option (Part Number 692-19-011)

$750

3/8" center height option (Part Number 692-19-012)

$100

Short cycle spindle drive option for C axis drive

$500

Foredom live tool including: 220V single phase 1/4hp motor - 20,000 rpm max, spindle, drive shaft, speed controller, 1/8"" & 1/4"" collet, lubricant for spindle bearings. - Requires M function outlet, 220V single phase

$550

Suhner live tool - light duty - Minifix drive, NA7 cable, BEWI-4 spindle

$1,735

Suhner live tool includes motor - 1,020 to 14,400 rpm in 7 steps via gear box., spindle - uses ER16 collets - 10mm max, drive shaft. 1.36hp, 220V 3 phase. - Requires M function outlet, 220V three phase

$2,575

M function controlled outlet: 220V three phase

$395

M function controlled outlet: Pneumatic with FRL

$395

M function controlled outlet for NSK Astro-E

$395

Lag bolt kit for OmniTurn GT-75 and GT-Jr

$110

TripleAir pneumatic bar feed - 12' x 1-1/16"

$3,490

OmniTurn 3" - 2 jaw chuck, .25"" diameter stroke, blind, max 5000 rpm.

$2,295

OmniTurn 4" - 3 jaw chuck, .25" dia. stroke, blind, 5,000# holding force.

$2,495

OmniTurn 4.5" - 3 jaw chuck, .17"" dia. stroke, 1" through hole, 4000# holding force.

$3,295

Through the spindle coolant, M function controlled

$950

Through the spindle air blast, M function controlled

$750

Part Conveyor - installed at factory.
Price does not include Required M function controlled outlet, 110V. Or the conveyor runs continuously. M function outlet is $225 if spare M function is available.

$1,750

Pneumatic tail stock

$1,995

Additional I/O package, 8 in/6 out, programmable from Control

$795

* Startup by OmniTurn Tech. - Travel and expenses billed at cost

$750