Simultaneous 2 axes moves: X & Z          

9" CRT display                                            

Operator station

Industrial Hard Drive

Full screen text editor

Tool nose radius compensation

Auto corner chamfering & radiusing

Program verification

Tool path graphics

Decimal point programming

Combined use of absolute/incremental

Inch or metric programming

Radius or Diameter programming

Program storage: 9000 plus floppy disk backup

RS-232 interface

         Automatic mode
                -looping, sub-routines
                -program run
                -single block operation
                -continuous mode
                -Optional block delete
                -block search to
                -tool offset correction
                -Secondary offset correction (taper correction)
                -program editor
                -spindle override on/off & 0-150%
                -editor lock

Automatic mode (continued)

           -Disk operations
           -delete programs
           -rename programs
           -duplicate system or program disk
           -remote connections via RS-232

Constant surface speed control

Tool offsets: 32 per program

Secondary offsets: 32 per program

Sub Routines: 10 per program

Parts counter

Count-down counter for bar feed work

Least increment: .00005"/.001mm

Work shift offsets

NO BATTERY backup necessary

No air pulled through control for cooling

Jog mode with joy stick
            -continuous modes: 1, 10, & 100"/min.
            -incremental:.00005", .001", .01", .1", 1"

        Threading- Inch/Metric, OD/ID,
                    -Tapered, Multi start,
                    -Angle in feed, single pass

MDI mode

M12/M13 collet control

M08/M09 coolant control

M03/M04/M05 spindle control

M19 C axis spindle control (optional)

         M25/M26 defined by user

Rapid travel: 300 ipm

Accel to 300 ipm in .06 sec

Feed rates:.00005" per rev to 450 ipm

Thrust: 500# cont., 750# intermittant

Servo update time: .001 second

Servo gain: 4"/min/mV

 Arc sphericity: +/- .00005"

Add'l I/O interface $795. Useful for:
    -parts catcher
    -automatic loader
    -live tooling
    -bar feeds
    -automatic door closer
    -end of cycle light
    -tailstock
    -spindle Brake

Modem for remote access

C axis control: spindle indexing, helical milling

Ethernet cards for network connections

Vision system interface

Removable hard drive